Bad_data_empty_water_samples

Algorithm

Bad_data_empty_water_samples is an analysis export variable.

It reports the number of samples, in the domain which was analyzed, that are in "applied" Bad data (empty water) regions. "Applied" is achieved by selecting Apply bad data regions under the Analysis section of the Analysis page of the Variable Properties dialog box

This variable is only exported if it is selected on the Export page of the EV File Properties dialog box.

See also

About analysis
About analysis variables

Samples (algorithms)
About Good_samples
Samples_in_domain
Bad_data_no_data_samples
No_data_samples
Samples_Above_Surface_Exclusion
Samples_Below_Bottom_Exclusion
About C__good_samples
About C_no_data_samples
About C_bad_data_no_data_samples 
About C_bad_data_empty_water_samples