Calibration settings for Sv to TS and TS to Sv virtual variables
Calibration settings for virtual variables created using the Sv to TS operator and the TS to Sv operator are listed on this page. See Calibration settings for virtual variables for further information about virtual variable calibration.
The table below lists specific settings and how they are used:
- Settings that are used to calculate the data point value are indicated with a P.
- Settings not used for data point calculation may be used for other calculations.
Some settings may not be available for all variables. We recommend you fill in all settings available on the Calibration pages for each variable (see Echoview calibration supplement files).
Setting |
Data point value (TS) |
---|---|
P |
|
P |
|
P |
|
P |
|
P |
|
P |
Note: The default values on the Calibration page are for illustration purposes only and may not be applicable for the variable. Read About calibration settings for further information.
Additional notes for Sv to TS and TS to Sv virtual variables:
- See the Sv to TS algorithm or the TS to Sv algorithm for clarification on how the settings for calibrated data are used.
- See Choosing a calibration offset to determine how the calibration offset setting affects the accuracy of the Sv to TS conversion.
- TvgRangeCorrection may be specified or applied as a default for some data formats.
See also
Calibration settings for virtual variables
About calibration settings
About virtual variables
Entering calibration settings